When logged into the flashed image, this is what the firmware soft_config show:īoot_device: eth ethonce flash cfg cfgonce However, a soft or hard reboot gets the endless bootp calls going again. When I press the reset button after the flashing has completed and the device is making its bootp requests, this is seen by the bootloader and it then boots the image from flash without issues. Problem: after the flashing has been done the device reboots but does not load the fresh image from flash, but tries to get bootp going again. 2022 home compile r21516+5-1b8c8864c5.ġ00% OK: loading and booting kernel.bin image via bootp.Īlmost OK: sysupgrade of sysupgrade.bin image Tests here: Mikrotik SXTsq-5ac upgraded to ROS 7.7rc5 and OpenWrt Dec. Would like to share some experiences so far and perhaps somebody has an idea to overcome the last hurdle. Of course it would be better to figure out what is wrong and correct that. Since some time a warning is given in the general Mikrotik/OpenWrt instructions to downgrade to a v6 ROS before attempting a sysupgrade.

Routeros version 7